Select your toy
Table of Contents
LIFT4 or LIFT5
If you need to open a compartment to insert the battery, you’re using a LIFT4.
If the battery clicks directly into place from the top without opening any hatches, it’s a LIFT5.
LIFT4 – Assembly & Use Guide
How to assemble the eFoil
Place the mast into its position and tighten the 4 screws located on the underside of the board.
Use the Allen key included in the charger box.
Connect the 3 cables (green, yellow, and red) to the corresponding colored ports.
Connect the blue tube from the mast to the blue tube from the board.
How to connect the battery
Place the battery in position and turn the latch to secure it.
Connect the data cable (small).
Then connect the power cable (large) and lock it with the second latch.
Turn on the board.
To disconnect:
First turn off the board and wait until the power button stops blinking.
Then disconnect the power cable, followed by the data cable.
How to charge the battery
Connect the data cable first, then the power cable to the charger.
Lock them in place with the latch, and plug the charger into a power source.
To disconnect:
Unplug the charger first, then disconnect the power cable, and finally the data cable.
How to pair the remote control
Classic remote (black and white screen):
Make sure the LIFT4 board is turned on.
With the remote off, press and hold the power button along with “+” and “-” simultaneously.
A Bluetooth symbol will appear.
Press and hold the side button just below the power button.
A checkmark will appear on the screen confirming successful pairing.
Elite Hand Controller (color screen):
Turn on the LIFT4 board.
Press the top-left power button on the remote to turn it on.
Open the menu using the top-center button.
Select the first option to begin pairing.
Press and hold the side button until it shows as connected and displays the board’s battery level.
How to attach the Blowfish
Stand the board vertically (resting on its base and wing).
Place the Blowfish in position while deflated.
Inflate it only after it’s correctly placed.
Secure it using the velcro straps.
LIFT5
Turn the board upside down and open the mast hatch (vertical position).
Insert the mast and close the hatch.
To attach the wing, press the small latch first, then open the larger one.
Insert the wing and close the latch to lock it.
Insert the battery by placing the bottom side first, then press the top in and close the handle.
Power on using the button located just below the handle.
How to charge the battery
Place it in the charger, close the handle, and plug it in.
To disconnect:
Unplug first, then open the handle to remove the battery.
How to attach the Blowfish
Stand the board vertically (resting on its base and wing).
Place the Blowfish in position while deflated.
Inflate it only after it’s correctly placed.
Secure it using the velcro straps.
SEABOB
How to turn it on
Press and hold the blue button.
When “Seabob” appears on screen, pull the trigger until it powers on.
How to control the speed
Green button: Increases speed.
Red button: Decreases speed.
How to charge the Seabob
On top of the Seabob, twist and remove the circular cap to access the charging port.
Plug the charger into a power source before connecting it to the Seabob.
⚠️ WARNING: Always make sure the charging port is completely dry before use.
Rules & Safety Guidelines
Use of toys is strictly forbidden in swimming areas. Only use in zones where navigation is allowed.
Always use the safety buoy provided with your rental when operating a scooter (Seabob, Vapor, or Jobe).
Helmet and life vest are strongly recommended at all times when using an eFoil.
Wearing a life vest is mandatory when riding jet skis.